Wide rims or slim rims racing4/4/2023 Most aftermarket wheels are aluminum wheels (or alloy wheels if you prefer) which do offer a performance advantage over steel wheels. Finally, a zero offset means the mounting face is right in the middle of the rim. A positive offset means the wheel’s mounting face is toward the front of the wheel, while a negative offset puts the mounting face toward the back, or inside of the wheel. You have negative, zero and positive offset custom wheels. This measurement is important when deciding on new wheels for you ride, but you will also need to know the wheel’s offset. Use a straight edge across the back of the wheel, and then use a measuring tape and measure the distance between the wheel’s mounting surface to the straight edge. A wheel’s backspacing is the measurement from the mounting face to the wheel’s rear lip. Then you have to take wheel offset and backspacing into account. Using a measuring tape, go from bead seat to bead seat across the front of the wheel, remembering to not use the wheel lip as the measuring point. The diameter of the wheel is measured across the face of the wheel and uses the tire bead seat as the measuring point, not the lip of the wheel. In other words, don’t measure from actual wheel lip to wheel lip, measure at the spot where the tire seats on the wheel on each side. The width is measured from the inner bead seat to the outer bead seat. First off, the width of the wheel is measured from what is called the wheel’s bead seat. To know if you have 15x7 wheels or 15x8 wheels, or if you want to add 15x9 wheels or even 15x10 wheels, you first need to know how to measure wheels. When it comes to measuring for custom wheels, your best friend is a measuring tape. What Is the Best Method to Measure Wheels?
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |